Industrial centrifuge used in a material separation application
03 APPLICATION ATLAS

Separation directions for different materials and production realities.

Each industry is a starting point. Equipment suitability and performance are confirmed only after the actual feed and target are reviewed.

APPLICATION DIRECTIONS

Five routes into the selection process.

Contact materials, wear protection, hygiene, cleaning and discharge arrangements remain project decisions.

Environmental sludge dewatering application
01 · ENVIRONMENTAL

Water & Sludge Treatment

Continuous thickening or dewatering discussions based on feed solids, treatment chemistry, cake target and clarified-liquid requirement.

Review
Feed solids and treatment chemistry
Define
Cake and clarified-liquid targets
Send sludge data
Food processing decanter centrifuge
02 · FOOD

Food & Starch Processing

Review product recovery, sanitation expectations, cleaning workflow and compatible wetted materials for food suspensions.

Review
Product recovery and sanitation
Define
Cleaning and wetted materials
Discuss food process
Chemical slurry separation equipment detail
03 · CHEMICAL

Chemical Processing

Assess corrosion compatibility, temperature, particle behavior, wear conditions and the required separation result.

Review
Corrosion, temperature and particles
Define
Wear protection and target result
Review chemical conditions
Mineral slurry separation equipment detail
04 · MINERALS

Mineral & Pigment Slurries

Evaluate abrasiveness, particle distribution, solids loading and discharge behavior before selecting protection and controls.

Review
Abrasiveness and solids loading
Define
Protection, discharge and controls
Send slurry data
Decanter centrifuge for oil processing direction
05 · OILS

Oil & Multi-Phase Processing

Where three-phase separation is required, define the liquid phases, solids load, interface conditions and recovery priorities.

Review
Liquid phases and solids load
Define
Interface and recovery priorities
Discuss phase separation
MATERIAL BEFORE MODEL

Tell us what enters and what must leave.

  1. 01 Material composition
  2. 02 Density difference
  3. 03 Feed solids
  4. 04 Required capacity
  5. 05 Target output
  6. 06 Operating conditions
Request an application review